Semi-Electric Stacker Power Unit

General Description

This power unit is specially designed for semi-electric stacker,The manual unloading valve is equipped with manual micro switch,The lifting and falling of the stacker are controlled by the handle of the unloading valve,and the falling speed is automatically controlled by the built-in pressure compensating throttle valve.

Outline Dimension

Hydraulic circuit optional 006

Model Specifications

Special Notes

1.For different flow rate pump,pressure and motor power, please check the ordering guidance.

2.This motor is based on gap working system S2=2 ~ 4min(continuous working time), so lit cannot run continuously.

3.Before installation,the cylinder,oil pipe,joint and other hydraulic components must be cleaned and free from any impurities.

4.The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities.HiM46 hydraulic oil is recommended.

5.This hydraulic power pack is suitable for horizontal installation.

6.Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

7.The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oil every 3,000 hours after that.