Hydraulic Climbing Ladder Power Unit

General Description

This power unit is speclally designed for the hydraulic climbing ladder of flatbed truck, which can realize the lifting and turning function of the ladder by the solenoid valve.

Outline Dimension

Hydraulic circuit optional 061

Model Specifications

Special Notes

1. For different flow rate pump,pressure and motor power,please check the ordering guidance.

2. This motor is based on gap working system S2=8 - 12min(continuous working time),so it cannot run continuously.

3. Before installation,the cylinder,oil pipe,joint and other hydraulic components must be cleaned and free from any impurities.

4. The viscosity of hydraulic oil should be 15-68cst and should be clean and free of impurities.HM46 hydraulic oil is recommended.

5. Check that whether there is enough oil in the oil tank immediately after the first operating of the system.

6. The hydraulic oil should be replaced after the first 100 hours'use of the system, and change the oil every 3,000 hours after that.